Update 'README.md'

README.md

@@ -1,21 +1,21 @@
 # DS18B20_raspi
 
-## Read first
-https://pinout.xyz/pinout/1_wire
-https://www.raspberrypi-spy.co.uk/2018/02/enable-1-wire-interface-raspberry-pi/
+## Read first  
+https://pinout.xyz/pinout/1_wire  
+https://www.raspberrypi-spy.co.uk/2018/02/enable-1-wire-interface-raspberry-pi/  
 
-For grafana Influx:
-https://pimylifeup.com/raspberry-pi-grafana/
-https://pimylifeup.com/raspberry-pi-influxdb/
+For grafana Influx:  
+https://pimylifeup.com/raspberry-pi-grafana/  
+https://pimylifeup.com/raspberry-pi-influxdb/  
 
 
 ## Hardware
 
-Connect the DS18B20 to the raspberry pi
-Raspi  - DS18B20
-3V3    -> VIN
-GND    -> GND
-GPIO 4 -> DATA
+Connect the DS18B20 to the raspberry pi  
+Raspi  - DS18B20  
+3V3    -> VIN  
+GND    -> GND  
+GPIO 4 -> DATA  
 
 Rember to add a 4K7ohm pull-up resistor between VIN and DATA on the sensor!
 
@@ -38,21 +38,21 @@ Enable and start the timer:
 
 If you want the script to be stores elsewhere (not in /home/pi/tempsense/.) then you have to edit the file (as root!) /etc/systemd/system/report_temperature.service
 
-Just change the line:
+Just change the line:  
 ExecStart=/home/pi/tempsense/temperature_reporter.py
 
 ## Configure the script before running.
 
 in temperature_reporter.py
 
-comfigure:
-'
-INFLUX_IP = ""
-INFLUX_PORT = 8086
-INFLUX_DB = ""
-INFLUX_USER = ""
-INFLUX_PASS = ""
-'
+comfigure:  
+'  
+INFLUX_IP = ""  
+INFLUX_PORT = 8086  
+INFLUX_DB = ""  
+INFLUX_USER = ""  
+INFLUX_PASS = ""  
+'  
 
-You can give the sensors costum names to be reoported by configuring the in the device names:
+You can give the sensors costum names to be reoported by configuring the in the device names:  
 device_names = {"28-000000000000":"Sensor_Name"}